Good Waterproof Vee Lip Type FIG 607 Drilling Seal Rings For 6000 PSI Hammer Union

Other types

For a Figure 607 vee lip seal enquiry, provide the nominal size, equipment identification and mating groove drawing. Confirm the lip profile and orientation against the connection design. Pressure suitability depends on the complete union assembly and the qualified seal compound.

Other union figures require separate groove and ring identification. Do not assume a Figure 607 vee profile is interchangeable with lip rings or O-rings listed for Figures 1502, 602, 206 or other connections.
Specify NBR, FKM or HNBR compound requirements with fluid formulation, temperature and pressure cycles. Brass or stainless steel backup construction needs dimensional review. Sour-gas service requires compound-specific qualification; PTFE or PU alternatives require separate grade and geometry approval.

Replacement selection and inspection:

Installation check: Confirm groove condition and seal orientation, then follow the equipment installation procedure.
Assembly acceptance: Agree the required assembly leakage and pressure test criteria; a replacement seal alone does not establish leak-free performance.
Condition inspection:Check for cuts, extrusion, lip damage and permanent deformation before reuse.
Order identification:List Figure 607, nominal size, groove drawing, compound and quantity for each replacement item.
Send the mating drawing and service conditions to review the replacement ring and any backup construction.

What we Shanghai Qinuo Industry Provide:

Rubber O rings

• Rubber O rings -As568 series rubber o rings/JB standard rubber o rings.
• Encapsulated rubber o rings- silicone/ FKM rubber o rings
• PTFE coating rubber o rings-kinds of color rubber o rings

Hammer Union seals- 1" 1.5" 2" 3" 4" 6" 7"

• Rubber hammer union seals-Buna/FKM/HNBR rubber type
• Rubber w/brass or stainless steel back up types

Swab cups

• V types 4" 5.5" ect.
• TA type
• MV type
• NUF type
• TUF type

Rubber seal kits- custom packing or lable is available

• #10 setting tool - With burst disk
• #20 setting tool - With burst disk
• AP Compact Setting Tool Kit
• Grease Tubes Seal Kit
• 3 1/2” Shorty Kits
• 3 - 1/8" Weight Bar Kit
• #10 Baker Firing Head Kit
• #20 Firing Head Kit
• #20 BP3.SEC kits
• #10 BP3.SEC kits
• T-BRT redress kit
• T-1 Set
• GC Stripper Head Redress Kits

Wireline Component Parts:

1) Pressure Relief Disc, ZD Plated (application:rupture(bleeder) Disc)

2) Rubber Push Pin -black

3) Nylon Push Pin -natural

4) Retainer Nut, Steel, ZD Plated (Flat, beveled also available) (application: retainer nut)

5) Threaded Steel Plug, w/ Lathe Cut (application:5" port plug)

6) Threaded Brass Plug (application: setting tool plug )

Rubber Packer Elements:

Rubber Oil Savers:

FAQ: